Last Updated on February 16, 2023 by Tabraiz

Introduction

Water heaters, or geysers, are as delicate as other electronic devices. Although manufacturers make the best parts to withstand constant heating and cooling, it is crucial to remember that even the most durable parts can be damaged by continuous pressure. Take help of an expert for water heater installation.

We will discuss tips and tricks for water heater maintenance to extend its lifespan despite regular expansion and contraction due to heating and cooling.

Average Lifespan of Water Heaters

Proper maintenance typically extends the life expectancy of gas water heaters to 8-12 years, and adequately maintained electric heaters can last between 10 and 15 years.

While it is true that water heaters today are more durable than older models, proper maintenance is still necessary to ensure they last for many years.

Water Heater Installation: Thing to remember

Keep the water heater at the proper height.

Experts recommend that the geyser be installed at least 1.8m (6 feet) above the ground. This will ensure that your water pressure is adequate and that you have vital hot water flow from the tap rather than a trickle.

Switches and electrical connections

Keep the switch at an appropriate height so that children are not in direct contact with it. However, you should not be able to reach it from a high place where adults or children may have problems.

We now know the best precautions for installing a water heater. The next thing you could take care of is.

Space

Remember to leave enough space between the water heater and walls when installing it.

Although some people place the geyser on top of the toilet for easier access, it makes it difficult for technicians to reach the device. It is better to place it on a wall with nothing below the geyser, away from damp areas such as the toilet, shower, or bathtub. You or anyone else can access it easily with a small stool.

Water heater maintenance tips

Before winter, make sure to inspect the anode rod in the tank.

More enormous geysers contain an anti-corrosion rod within the tank.

Experts recommend that the anode rod be checked every three years to ensure that the outer layer of magnesium is not corroded and that 6 inches or more remains of the inner steel core. It must be replaced if the rod is covered with whitish calcium particles (when water is hard) or if its thickness has fallen to less than half an inch.

Lowering the temperature can help you save more electricity.

It is vital to maintain your water heater, and you will also save electricity! A lower temperature will mean the geyser has to work less, increasing its lifespan. The geyser should not be left on for prolonged periods.

It is generally believed that everyone needs warm water before going to work or school, so it is worth keeping the geyser running. It is better to turn the geyser off for 5 minutes before you use it and not wait half an hour. Your heater’s life expectancy can be extended by regular water heater maintenance.

Pay attention to the plug.

Your switch will occasionally spark due to power fluctuations or low-capacity wiring.

It is better to use new plugs and sockets which have been appropriately wired and plugged in to prevent future short circuits. An MCB switch is better than a regular plug and will prevent short circuits from occurring. You can also ensure that the geyser is turned on only when needed and then turn it off after it has finished.

Give it space

You can save money in the long-term and stress by giving your water heater lots of space. You will need to ensure enough space for the water heater when choosing an area where it can be installed, and it shouldn’t feel crowded.

This allows you to complete routine maintenance checks without any difficulty.

This allows the system to get the much-needed oxygen it needs. It also increases airflow, which reduces the chance of fires. After you have found the ideal spot, remove any cleaning products and tools, such as vacuums, mops, or other tools, from the area.

Replacing the outlet and inlet pipes made of plastic with metal is a good idea.

Metal inlet and outlet pipes are better than standard plastic ones and more heat resistant than standard plastic ones. If you notice whitish deposits or rust around your joints, it’s time to replace the outlet or inlet pipe.

Add an expansion tank.

An expansion tank can increase your water heater’s life expectancy, especially for water heaters with closed systems that don’t allow backflow to the main water supply.

This is why water expands and has no place to go.

Your water heater is subject to constant pressure changes, which can cause it to wear down. An expansion tank allows the water heater to have an outlet, reducing the system’s stress.

Insulation Installation

Insulation should be placed around pipes and heaters. Use a foam self-sticking insulation 3/8 inch thick.

Insulation can be used to cover the cold and hot water pipes. As much as possible, cover the pipes, and this prevents the pipes from forming condensation or sweating in the summer.

You should wrap the pipes with a 1-inch unfaced fiberglass pipe wrap if they are less than 6 inches from the flue.

Conclusion

These are the most straightforward steps to increase the lifespan of your water heater. These simple tips can prove difficult for those who don’t know much about water heaters. Get water heater installation by an expert who can help you with water heater installation if your heater is in dire need of maintenance, repairs, or replacement.

Author Bio:-

Name:- Aimee Grace

Aimee is a marketing manager at EZ Plumbing & Restoration. She is very passionate in writing about discrete plumbing services and leakage detection as well as repair solutions. Her vision is to educate people about the consequences of water and slab leaks at home or office and what they should do to repair them to avoid further water damage as well as property damage.

Innovations have paved a way for smart devices to lead a convenient life. The plumbing industry is no different but only few people know about various tools used to fix the leakages. Stay tuned with the recent articles to know all about how to find water damage, slab leak, clogging, and ways to repair them, installation of new HVAC appliances in San Diego.

Apart from this, If you want to know about How to Repair a Leaky Water Heater then please visit our Home improvement category